Average Reviews:
(More customer reviews)This item is BR1500, which also called RS model vs. the BX1500 called XS models. External battery BR24BP can be used for both BR1500 and BX1500. The capability to connect external battery is great, since that can help reduce the downtime when California experiencing "rolling black" in the summer.
There are basically 2 differences between the Back-UPS RS(BR1500) and the Back-UPS XS (BX1500) models besides their names.1. The Back-UPS RS models have both 1-line 2-wire phone/fax/modem data-line protection and 10/100base-T ethernet protection, where as the Back-UPS XS models only has 1-line 2-wire phone/fax/modem protection.
2. The Back-UPS RS models have both Boost* and Trim** as features of Automatic Voltage Regulation (AVR), where as the Back-UPS XS only has Boost. When the input voltage increases above the high transfer point of a Back-UPS XS model it will only go to battery.*AVR Boost: The UPS is compensating for a low utility voltage. While the UPS can run in this mode indefinitely without any negative impact on the UPS, the circuit should be checked by a qualified electrician if the utility voltage is consistently low.
**AVR Trim: The UPS is compensating for a high utility voltage. While the UPS can run in this mode indefinitely without any negative impact on the UPS, the circuit should be checked by a qualified electrician if the utility voltage is consistently high.
BX1500 does not have the AVR trim feature, when AC line voltage is higher than spec, it will switch over the battery power till the line voltage drops into the spec range.
Please note this is called "backup UPS", not the "smart UPS" line. Backup UPS does not produce pure sine wave. When power lost, it will take some milli-seconds to switch over to battery power. "Smart-UPS" produces sine wave and the output AC was from DC source all the time. When AC input lost, the AC output will not have any interrupt.
For most computers, the "backup-UPS" is good enough, since the power supply inside PC always have capacitors that can hold for about 100MS or longer. When "backup-UPS" switched over in about 20MS, the computer will continue operates without much impact. But for A/V equipment, this may be an issue, especially the output is not pure sine wave. I would not recommend use this UPS for A/V equipment.
Click Here to see more reviews about: APC BACK-UPS RS BR1500 1500VA/865W UPS System
APC BACK-UPS RS BR1500 1500VA/865W UPS System
Click here for more information about APC BACK-UPS RS BR1500 1500VA/865W UPS System
0 comments:
Post a Comment